79-87 El Camino LED tail lights

1979 Non-Sequential LED's with reverse for El Camino

Each system contains 104 red 5mm super bright LEDs per side. The reverse light contains 12 white 5mm super bright LEDs per side. Although this system requires the modification of each rear lens, the increased amount of light more then justifies the work required. Each LED board fills the entire red section of the lens as shown in the lower photo. The housing is modified allowing the LED board to sit flat within the housing. A Dremel tool is recommended, but is not required to complete the modifications. A clear silicon is used to hold the LED boards in place. A plastic adhesive is used to re-seal the lens and housing.

CAUTION:

DO NOT USE ANY TYPE OF SUPER GLUE. SUPER GLUE, WHEN USED IN THIS APPLICATION, IS VERY BRITTLE AND WILL NOT HOLD THE LENS AND HOUSING TOGETHER

The non sequential LEDs plug into the OEM bulb socket using our 1156/57 bulb wire harness. The sequential system installs using our exclusive computer control. Simply tap three wires into the OEM wire harness and plug into the fuse panel.

Non Sequential MSRP $125.95

With Reverse Lights $169.95

Sequential MSRP $149.95

With Reverse Lights $175.95

Select options below.