New S hose in 3 layer silicone. Hard to find S-Hose for the Turbo V-6. The S-hose fits between the…
NewHeater control valvehoses in 3 layer silicone. Hard to find Heater control valve -Hoses for the Turbo V-6. The Heater…
Meziere Electric water pump. Polished heavy duty pumps for Buick V6motors.…
Turbo Buick 89 TTA Water Pump & Gasket…
This unit is for the heater control on the all Gbody cars.
They commonly go bad. If you are flushing…
This is the Intake air temperature (IAT) sensor or Manifold Air Temperature sensor(MAT) for 86/87 Turbo Regal and the 1989…
GBR-PEN-GBP-MATS67* $35.00
This kit replaces the original factory rubber shroud around the radiator. Same thinkness as factory. The rubber baffle that goes…
This Kit includes our Dual Fans set-up with Caspers Hi-Low Fan Relays, 160 degrees thermostat, Aluminum thermostat housing, aluminum thermostat…
1978-1988 G-Body RADIATOR CORE SUPPORT REPRODUCTION BUSHINGS/CUSHIONS (2) KIT
These are reproduction replacements for the factory core support bushings/cushions.
Our Kit includes…
86-7 Buick Grand National
Fan Delay Relay: Controlled by a solid state timer to run for 10 minutes when the…
Cooling fan temperature switch. Replaces the discontinued GM sensor. Fits all 86-87 Turbo Regal and 89 Turbo Trans Am. Check…
Replacement cap for coolant bottle
Fits all GBodys…
This unit is for the heater control on the all Gbody cars. Steel has been discontinued and this is the…
New Z hose in 3 layer silicone. Hard to find Z-Hose for the 86-7Turbo V-6. The Z-hose fits between theheater…
86-87 Turbo Buick dualfans with caspers Hi-low fan relays.
Our dual fans are 3140 Combined CFM. When used in…
GB0-PEN-GBP-DFWR* $265.00
GBodyParts.com Stainless steel coolant lines.
They constantly rust from the inside out. They bend on the flare end upon removal…
GB0-AEN-C31-SSCLP $109.95
GBodyParts.com Stainless steel coolant lines.
They constantly rust from the inside out. They bend on the flare end upon removal…
GB0-AEN-C31-SSCLB $109.95
This is the 1/2" NPT fitting nipple that is required to install your coolant line to your intake manifold.
Replaces steel…
GB0-PEM-C31-NPTFNA $11.95
This is the 1/2" NPT fitting nipple that is required to install your coolant line to your intake manifold.
Replaces steel…
GB0-PEM-C31-NPTFNL $11.95
Displaying 1 to 20 (of 37 products)