Factory appearing Fuel Injector harness using 14 gauge wire, recommended for use in high performance racing applications where low impedance…
Fuel Pump Test Tap Splice - 1984 / 1985 This connector is found behind the alternator, single black connector with gray…
Absolutely essential upgrade item for your turbo car! Increases fuel pump volume by 15% or more! By far the finest…
Replaces damaged connectors for fuel pump/sender. Kit contains two mating connectors with wiring. similar to our GN tank kit except…
Location: Starter stud. Replace blown/broken/corroded fusible links with thisreplacement kit; 4 links go to 5-12 gage wires.
Price is $22.95
…
Located on the engine harness, 89 TTA, connects to the positive battery cableand provided two 12 gage feeds. Frequently a…
HD Fuel Pump / Fan Relay Kit 40 AMP This kit is designed for high current applications such as high power…
Heated O2 Sensor Kit ONLY 86/87 Wiring Harness Plug-and-Play harness installs in minutes with NO wires to cut or splice. Harness…
Eliminate electrical "gremlins" with a new cable. Our negative cable is manufactured to OEM specifications, using the new "slip-over" terminal…
Powermaster Harness This harness is designed to be used when the Powermaster power brake unit is transplanted into another vehicle. Plug-and-play…
The Scanmaster has been the must-have device for all Turbo Buick owners since 1993!! Now updated to 21st century technology!!…
Enables addition of SPAL dual fans to the turbo Trans-Am. Plug-and-Play. Price is $30.95…
Plug-And-Play unit inserts between your TPS sensor and TPS wiring. It has two functions; one, it allows you to calibrate…
This harness is designed to feed low impedance injectors in race applications. Using direct feed from the positive bus, the…
Plug-in device amplifies tach signal from CCCI ignition system which would otherwise not drive a typical aftermarket tachometer. 3 wires…
If you have a Powerlogger, this can be connected to monitor and datalog air/fuel ratio.
The Inline Wideband UEGO gives all…
These AEM Power replacement wideband O2 sensors are used in AEM single channel UEGO systems. They may also work with…
This Plug-And-Play adapter module is designed to permit the XFI Fuel Management Computer to directly interface with the electrical system…
